Anti-static rubber mats, roll-type anti-static flooring anti-static mat floor coverings method a basic ground requirements: 1, basic ground for a smooth surface concrete floor, terrazzo floors, ceramic tile floor, wooden floor. 2, the ground must be flat, no significant irregularities, roughness to less than a fraction of 3, ground has enough strength and no sand, shell phenomenon. 4, the ground must be dry. Second, the construction procedures and specific method, clean the floor with a cleaning liquid waste matter (with washing machine) 2, laying the ground grid grounding conductor copper strip thickness of 0.02mm, a width of 20mm, the number based on the ground to determine the actual width requirements length and number (copper strip direction and the direction perpendicular to the anti-static mat, a copper bar spacing 2-3m), while the copper bar at one end toward the ground laying outdoor grounding. 3. After laying the ground conductor grid, the anti-static Mat turn to fight on the ground, if the gap between the pad too, can cut straight knife to make the gap smaller. The laying of a good anti-static mat in the mat and turned edge (about 20cm), in a gap in the middle position water glue (401 glue or double-sided tape), dry for 20-30 minutes, until the hand stick, (double-sided tape Now you can bond), the same anti-static bottom surface (black face) operations (coating evenly once, double-sided adhesive tape applied to the ground level, anti-static bottom surface does not require double-sided sticky tape), then anti-static mat and ground bond, and then re-roll rolled several times, it makes anti-static mat surface flatness can be neat (if there is heavy rollers rolled by hand or by foot click), at room temperature After 48 hours may be used.